topic Re: Analysis Engine not starting after 6.1 upgrade in Network Security https://community.cisco.com/t5/network-security/analysis-engine-not-starting-after-6-1-upgrade/m-p/957575#M80019 <HTML><HEAD></HEAD><BODY><P>Can you provide the output of commands "show tech" and "show version" which will help us in identifying the reason for the issue and resolving the same.</P></BODY></HTML> Wed, 21 May 2008 12:49:05 GMT smahbub 2008-05-21T12:49:05Z Analysis Engine not starting after 6.1 upgrade https://community.cisco.com/t5/network-security/analysis-engine-not-starting-after-6-1-upgrade/m-p/957574#M80018 <P>The Analysis Engine on my sensor is not starting after the upgrade to 6.1. </P><P></P><P>Also, when I use IDM to connect to the sensor it says:</P><P></P><P>Error connecting to sensor. Failed to create sensor - &lt;IP address&gt;.</P><P></P><P>Exiting IDM.</P><P></P><P></P> Sun, 10 Mar 2019 11:06:45 GMT https://community.cisco.com/t5/network-security/analysis-engine-not-starting-after-6-1-upgrade/m-p/957574#M80018 mcvosi 2019-03-10T11:06:45Z Re: Analysis Engine not starting after 6.1 upgrade https://community.cisco.com/t5/network-security/analysis-engine-not-starting-after-6-1-upgrade/m-p/957575#M80019 <HTML><HEAD></HEAD><BODY><P>Can you provide the output of commands "show tech" and "show version" which will help us in identifying the reason for the issue and resolving the same.</P></BODY></HTML> Wed, 21 May 2008 12:49:05 GMT https://community.cisco.com/t5/network-security/analysis-engine-not-starting-after-6-1-upgrade/m-p/957575#M80019 smahbub 2008-05-21T12:49:05Z Re: Analysis Engine not starting after 6.1 upgrade https://community.cisco.com/t5/network-security/analysis-engine-not-starting-after-6-1-upgrade/m-p/957576#M80020 <HTML><HEAD></HEAD><BODY><P>You might be running into this bug #CSCsm71528</P><P></P><P>Symptom:</P><P>After signature update or configuration change the AnalysisEngine shows NotRunning.</P><P></P><P>Conditions:</P><P>After a signature update or other configuration change.</P><P></P><P>Workaround:</P><P>None, to restore service reboot sensor. </P></BODY></HTML> Wed, 25 Jun 2008 12:57:29 GMT https://community.cisco.com/t5/network-security/analysis-engine-not-starting-after-6-1-upgrade/m-p/957576#M80020 avang2004 2008-06-25T12:57:29Z