topic ZBPF and SDM in Network Security

ZBPF and SDM

communication.boy — Mon, 11 Mar 2019 16:52:51 GMT

I am configuring Zone Based Policy Firewall using SDM . As per my knowledge if you use an older version of SDM or IOS you will get CBAC there in SDM but starting IOS 12.4(6)T that feature would be replaced with ZBPF which has got zones rather than those ACL . However when I am going to Configure - Firewall - Basic/Advance and when i Finish up with the configuration I cee that CBAC has been applied .

I am using SDM v2.5

and I have tried the following IOS

c2691-advsecurityk9-mz.124-6.T

c2600-advsecurityk9-mz.124-15.T3

c2600-adventerprisek9-mz.124-15.T9

Feature nagivator says that these both IOS supports ZBPF but I am not getting them in SDM .

Note: I am using GNS3 to emulate these stuff

Kindly help

Re: ZBPF and SDM

resoares — Fri, 01 Jan 2010 17:04:22 GMT

Hi,

Try this image: 12.4(15)T11 ADVANCED ENTERPRISE SERVICES

The link below explains how to proceed with the configuration on SDM:

http://www.cisco.com/en/US/docs/routers/access/cisco_router_and_security_device_manager/25/software/user/guide/ZPF.html

Br,

Re: ZBPF and SDM

communication.boy — Sun, 03 Jan 2010 01:41:15 GMT

Thanks Soares ,

It looked like it was a problem with GNS3 , I tested the same stuff in my office PC and everything worked fine .

BIG FAT WARNING : NEVER RELY ON EMULATORS

cb,