topic Re: Cannot load ASDM after upgrade in Network Security

Cannot load ASDM after upgrade

scudderconsulting — Mon, 11 Mar 2019 16:20:25 GMT

Not sure where I slipped up, but when I try to load ASDM I get an unable to load ASDM from <ip address> message.

wbdcfw# sh ver

Cisco Adaptive Security Appliance Software Version 8.2(1)

Device Manager Version 6.2(1)

Compiled on Tue 05-May-09 22:45 by builders

System image file is "disk0:/asa821-k8.bin"

Config file at boot was "startup-config"

wbdcfw up 3 mins 2 secs

Hardware: ASA5505, 256 MB RAM, CPU Geode 500 MHz

Internal ATA Compact Flash, 128MB

BIOS Flash M50FW080 @ 0xffe00000, 1024KB

...

platinum_jem — Tue, 29 Sep 2009 04:28:06 GMT

Make sure you have the following in ur config

http server enable

asdm image disk0://xxx

godinerik — Tue, 29 Sep 2009 08:14:54 GMT

You must also specify which addresses are allowed to access it:

http xx.xx.xx.xx netmask [interface] i.e:

http 192.168.100.0 255.255.255.0 inside

http 0 0 outside for all of the outside IPs. If all of that is done, clear your browser's cache/cookies, close all browser windows and re-open.

scudderconsulting — Wed, 30 Sep 2009 02:00:30 GMT

I didn't have 'http server enable' in my config. Thanks!