topic Re: ERROR when I try to enable Top usage Status in Network Security https://community.cisco.com/t5/network-security/error-when-i-try-to-enable-top-usage-status/m-p/1241109#M840872 <HTML><HEAD></HEAD><BODY><P>I was able to implement this via the ASDM GUI in the "configuration...threat detection" screen. From looking at your CLI command it would appear that 0 is not an option, you need to use an integer value between 1 and 3.</P></BODY></HTML> Sun, 03 Jan 2010 04:13:54 GMT smudholkar 2010-01-03T04:13:54Z ERROR when I try to enable Top usage Status https://community.cisco.com/t5/network-security/error-when-i-try-to-enable-top-usage-status/m-p/1241108#M840870 <P>When I try to enable Top Ten Sources I get the following error.</P><P></P><P>[ERROR] threat-detection statistics host number-of-rate 0</P><P></P><P>threat-detection statistics hosts number-of-rate 0</P><P></P><P>% Invalid dectected at '^' marker</P><P></P><P>ASA 5520</P><P>ASA 8.0(4)</P><P>ASDM 6.1(5)</P> Mon, 11 Mar 2019 15:35:06 GMT https://community.cisco.com/t5/network-security/error-when-i-try-to-enable-top-usage-status/m-p/1241108#M840870 rarmitage 2019-03-11T15:35:06Z Re: ERROR when I try to enable Top usage Status https://community.cisco.com/t5/network-security/error-when-i-try-to-enable-top-usage-status/m-p/1241109#M840872 <HTML><HEAD></HEAD><BODY><P>I was able to implement this via the ASDM GUI in the "configuration...threat detection" screen. From looking at your CLI command it would appear that 0 is not an option, you need to use an integer value between 1 and 3.</P></BODY></HTML> Sun, 03 Jan 2010 04:13:54 GMT https://community.cisco.com/t5/network-security/error-when-i-try-to-enable-top-usage-status/m-p/1241109#M840872 smudholkar 2010-01-03T04:13:54Z Re: ERROR when I try to enable Top usage Status https://community.cisco.com/t5/network-security/error-when-i-try-to-enable-top-usage-status/m-p/1241110#M840877 <HTML><HEAD></HEAD><BODY><P>Hi,</P><P></P><P>1. try to use the&nbsp; command #threat-detection statistics in CLI mode.</P><P>2, save the config disconnect and reconnect ASDM.</P><P></P><P>I have not met this situation, found a similar senario and resolution on the web.</P><P>hepe it works</P><P></P><P>Yang</P></BODY></HTML> Sun, 03 Jan 2010 17:08:24 GMT https://community.cisco.com/t5/network-security/error-when-i-try-to-enable-top-usage-status/m-p/1241110#M840877 YANGCCIE4 2010-01-03T17:08:24Z