which mode is working

iqbalkhan — Sun, 10 Mar 2019 10:56:58 GMT

In my network cisco IPS is working act as an IDS mode.

have any command that without see the physical connectivity and known the mode to see the IPS working as IDS mode or IPS mode or if have no like this command then BY IDM i can get the infrmation ?

Thanks

Biplob

Re: which mode is working

iqbalkhan — Wed, 23 Jan 2008 08:23:05 GMT

no commands !

Re: which mode is working

ovt — Thu, 24 Jan 2008 12:14:01 GMT

Yes, many commands can show this:

sensor# sh stat virtual-sensor

can give you a hint:

List of interfaces monitored by this virtual sensor = Pair1 subinterface 0

for IPS mode and:

List of interfaces monitored by this virtual sensor = FastEthernet0/1 subinterface 0

for IDS mode.

Or use:

S1# show interfaces brief

CC Interface Sensing State Link Inline Mode Pair Status

* FastEthernet0/0 Disabled Up

FastEthernet0/1 Enabled Up Unpaired N/A

FastEthernet1/0 Disabled Down Unpaired N/A

FastEthernet1/1 Disabled Down Unpaired N/A

FastEthernet1/2 Disabled Down Unpaired N/A

FastEthernet1/3 Disabled Down Unpaired N/A

for IDS mode or:

CC Interface Sensing State Link Inline Mode Pair Status

* FastEthernet0/0 Disabled Up

FastEthernet0/1 Enabled Up Paired with interface FastEthernet1/0 Up

FastEthernet1/0 Enabled Up Paired with interface FastEthernet0/1 Up

FastEthernet1/1 Disabled Down Unpaired N/A

FastEthernet1/2 Disabled Down Unpaired N/A

FastEthernet1/3 Disabled Down Unpaired N/A

for IPS mode.

Or use setup.

Re: which mode is working

iqbalkhan — Mon, 28 Jan 2008 17:17:48 GMT

thanks

topic Re: which mode is working in Network Security

which mode is working

Re: which mode is working

Re: which mode is working

Re: which mode is working