topic Failover traffic sync problem in Network Security https://community.cisco.com/t5/network-security/failover-traffic-sync-problem/m-p/1213723#M861426 <P>Hi,</P><P></P><P>If I permit udp traffic specifically in nat0 statement facing problem with configuration sync in failover. </P><P></P><P>Instead if I permit tcp or ip in nat0 statement every thing works fine.</P><P></P><P>What might be the problem?</P><P></P><P>Regards..</P> Mon, 11 Mar 2019 15:11:58 GMT souvik.mazumdar 2019-03-11T15:11:58Z Failover traffic sync problem https://community.cisco.com/t5/network-security/failover-traffic-sync-problem/m-p/1213723#M861426 <P>Hi,</P><P></P><P>If I permit udp traffic specifically in nat0 statement facing problem with configuration sync in failover. </P><P></P><P>Instead if I permit tcp or ip in nat0 statement every thing works fine.</P><P></P><P>What might be the problem?</P><P></P><P>Regards..</P> Mon, 11 Mar 2019 15:11:58 GMT https://community.cisco.com/t5/network-security/failover-traffic-sync-problem/m-p/1213723#M861426 souvik.mazumdar 2019-03-11T15:11:58Z Re: Failover traffic sync problem https://community.cisco.com/t5/network-security/failover-traffic-sync-problem/m-p/1213724#M861427 <HTML><HEAD></HEAD><BODY><P>You may try using the "nat-control" statement. The nat-control command on the PIX/ASA specifies that all traffic through the firewall must have a specific translation entry (nat statement with a matching global or a static statement) for that traffic to pass through the firewall. </P><P></P></BODY></HTML> Fri, 03 Apr 2009 14:03:16 GMT https://community.cisco.com/t5/network-security/failover-traffic-sync-problem/m-p/1213724#M861427 vmoopeung 2009-04-03T14:03:16Z