topic Re: Adding new hw to 5510 failover in Network Security https://community.cisco.com/t5/network-security/adding-new-hw-to-5510-failover/m-p/1236671#M876245 <HTML><HEAD></HEAD><BODY><P>Woohoo! <span class="lia-unicode-emoji" title=":winking_face:">😉</span></P></BODY></HTML> Fri, 20 Feb 2009 19:00:25 GMT eddie.mitchell 2009-02-20T19:00:25Z Adding new hw to 5510 failover https://community.cisco.com/t5/network-security/adding-new-hw-to-5510-failover/m-p/1236668#M876242 <P>I have two ASA5510 that are running failover (Active/Stand by). I need to add a 4 port module to each one of the ASA5510. How would I go about doing that? Do i have to shut them down to add the modules? Do I start with the Stanby first? I need your insight, please.</P> Tue, 26 Mar 2019 00:42:09 GMT https://community.cisco.com/t5/network-security/adding-new-hw-to-5510-failover/m-p/1236668#M876242 jmf3186fj 2019-03-26T00:42:09Z Re: Adding new hw to 5510 failover https://community.cisco.com/t5/network-security/adding-new-hw-to-5510-failover/m-p/1236669#M876243 <HTML><HEAD></HEAD><BODY><P>I would perform the following:</P><P>1-Shutdown the primary (should automatically failover to the backup node)</P><P>2-Install the new card on the primary</P><P>3-Shutdown backup node and install the card (downtime)</P><P>4-Power on both at the same time</P><P></P><P>I think the key here is to avoid having both nodes up at the same time with the SSM expansion card installed in one and not the other.</P><P></P><P>Hope this helps.</P></BODY></HTML> Tue, 17 Feb 2009 21:23:02 GMT https://community.cisco.com/t5/network-security/adding-new-hw-to-5510-failover/m-p/1236669#M876243 eddie.mitchell 2009-02-17T21:23:02Z Re: Adding new hw to 5510 failover https://community.cisco.com/t5/network-security/adding-new-hw-to-5510-failover/m-p/1236670#M876244 <HTML><HEAD></HEAD><BODY><P>Youa re Da man!! Thnak you Sir!!! Everything went smooothly successful</P></BODY></HTML> Fri, 20 Feb 2009 18:56:42 GMT https://community.cisco.com/t5/network-security/adding-new-hw-to-5510-failover/m-p/1236670#M876244 jmf3186fj 2009-02-20T18:56:42Z Re: Adding new hw to 5510 failover https://community.cisco.com/t5/network-security/adding-new-hw-to-5510-failover/m-p/1236671#M876245 <HTML><HEAD></HEAD><BODY><P>Woohoo! <span class="lia-unicode-emoji" title=":winking_face:">😉</span></P></BODY></HTML> Fri, 20 Feb 2009 19:00:25 GMT https://community.cisco.com/t5/network-security/adding-new-hw-to-5510-failover/m-p/1236671#M876245 eddie.mitchell 2009-02-20T19:00:25Z