topic Re: VPN IPSEC in Network Security https://community.cisco.com/t5/network-security/vpn-ipsec/m-p/1158350#M876748 <HTML><HEAD></HEAD><BODY><P>Issue solve !!!</P></BODY></HTML> Mon, 23 Feb 2009 05:47:22 GMT sibgathullah 2009-02-23T05:47:22Z VPN IPSEC https://community.cisco.com/t5/network-security/vpn-ipsec/m-p/1158348#M876746 <P>Dear All, </P><P></P><P>I have got ASA 5510 with 7.0 Version. i created a IPSEC site to site vpn, when i ping, i can see IKE tunnel 1 on asdm n then i get an error of QM FSM.... </P><P>I have done the configuration through ASDM only.How can i define these strings as this configuration i recive from the other side, </P><P>ISAKMP lifetime (phase 1)= 1440 minutes </P><P>SA (phase 2)= 7200 seconds </P><P>DPD= disabled </P><P>COMPRESSION= disabled </P><P>PFS= disabled </P><P>Can anyone help to me solve this issue and i wanna do it through ASDM. </P><P></P><P>Thanks &amp; Regards, </P><P></P> Mon, 11 Mar 2019 14:47:26 GMT https://community.cisco.com/t5/network-security/vpn-ipsec/m-p/1158348#M876746 sibgathullah 2019-03-11T14:47:26Z Re: VPN IPSEC https://community.cisco.com/t5/network-security/vpn-ipsec/m-p/1158349#M876747 <HTML><HEAD></HEAD><BODY><P>In the logs on ASDM you should see if there is something failing. Usually it will tell you if you are passign phase 1 and then you are on to phase 2. that's the first issue. If you are not passing phase 1 then your IKE parameters don't match on both sides. So make sure they do then you should be able to pass phase 1. Then Phase 2 is IPSec parameters..</P><P></P><P>HTH</P><P></P></BODY></HTML> Sat, 07 Feb 2009 12:56:23 GMT https://community.cisco.com/t5/network-security/vpn-ipsec/m-p/1158349#M876747 cdusio 2009-02-07T12:56:23Z Re: VPN IPSEC https://community.cisco.com/t5/network-security/vpn-ipsec/m-p/1158350#M876748 <HTML><HEAD></HEAD><BODY><P>Issue solve !!!</P></BODY></HTML> Mon, 23 Feb 2009 05:47:22 GMT https://community.cisco.com/t5/network-security/vpn-ipsec/m-p/1158350#M876748 sibgathullah 2009-02-23T05:47:22Z