topic Re: CSC-SSM access via CLI in Network Security

CSC-SSM access via CLI

new_networker — Mon, 11 Mar 2019 14:11:28 GMT

Hi,

Can the CSC-SSM module be configured via CLI. Or only GUI can be used.

Also is there any detailed configuration/Administration guide for CSC-SSM other than the document named "ASA: Send Network Traffic from the ASA to the

CSC-SSM Configuration Example

Document ID: 99141"

Re: CSC-SSM access via CLI

JORGE RODRIGUEZ — Tue, 11 Nov 2008 13:34:52 GMT

There is some cli for troubleshooting and other initial configuration, take a look at (CSC) sections.

http://www.cisco.com/en/US/products/ps6120/products_installation_and_configuration_guides_list.html

Re: CSC-SSM access via CLI

kwillacey — Tue, 11 Nov 2008 22:06:56 GMT

it can be done via command line but it's menu driven

Re: CSC-SSM access via CLI

SOL10 — Wed, 12 Nov 2008 15:41:59 GMT

you can access the module via CLI by entering the command session 1 from the global config mode.

also, the main configuration is done via the GUI, (like which traffic to block etc). However, you will need to create a policy-map using the cli, match it against an ACL and then apply to the interface(depending on how you will using the CSC module) if you want to stop the inside users downloading files apply to the inside interface, or if you want to stop client uploading files via a web app then apply to outside interface.

HTH, please rate if useful.

Regards

Sol