topic Radius privilege levels in Network Security

Radius privilege levels

mikedelafield — Mon, 11 Mar 2019 13:50:49 GMT

Hi I am struggling with getting my Cisco ASA to enforce privilege levels to users that authenticate to ASDM via Radius.

I am sending back the Priv-lvl=5 attribute but all users connecting to ASDM get level 15 no matter what?

Any ideas?

suschoud — Mon, 29 Sep 2008 14:18:47 GMT

Do you have :

aaa authentication http console LOCAL

LOCAL is needed if you want a fallback authentication in case radius server is unavailable.

Do rate helpful posts.

Regards,

Sushil

mikedelafield — Mon, 29 Sep 2008 14:30:28 GMT

i already have aaa authentication http console LOCAL set

the problem is that every authenticated users gets priv 15

suschoud — Mon, 29 Sep 2008 14:35:28 GMT

You can use following commands to set privilege level of specific commands. Next, if you create a username with-

-> 3 = Privilege < 5 : Can only â€œmonitorâ€ the device or can only run commands set at privilege level 3 (Refer commands below).

-> 5 = Privilege < 15 : Can only â€œsee configuration settingsâ€, refer to additional commands at level 5 below.

-> Privilege = 15 : Complete access to the device.

Note: Privielge level of all other commands not mentioned below are by default at privilege 15, exception are commands like â€œhelpâ€.

CHECK IF THE COMMAND BELOW IS PRESENT :

aaa authorization command

( MAKE SURE YOU HAVE AN ALTERNATE SESSION OPEN WHILE YOU SET AUTHORIZATION FOR COMMANDS TO AVOID A LOCKOUT.

Regards,

Sushil

mikedelafield — Mon, 29 Sep 2008 14:43:25 GMT

i know how to do this with local usernames, the problem is using RADIUS for authentication....

the Cisco AV Pair Priv-Lvl command doesn't seem to work or be adhered to by ASDM?