topic Re: ASA Security Context and RIP Routing in Network Security

ASA Security Context and RIP Routing

enforcers — Mon, 11 Mar 2019 13:43:25 GMT

I`m trying to verify some information but can find nothing of use on the cisco.com website or google. So, I turn to you guys/gals.

An associate in another business unit has purchased a few ASA 5580's and was told if he were to run multiple security contexts, he would not be able to utilize RIP for routing. Is this true or false. If this is true, can someone point me to a link where it says this is not possible. If it is false, I would really appreciate if there were a link somewhere on cisco's site where it stated this is possible.

Re: ASA Security Context and RIP Routing

Jon Marshall — Thu, 11 Sep 2008 18:23:40 GMT

You cannot run any dynamic routing protocol if you are running multiple contexts. Excerpt from ASA 8.x configuration guide

==============================================

This section describes how to configure static and default routes on the security appliance.

Multiple context mode does not support dynamic routing, so you must use static routes for any networks to which the security appliance is not directly connected; for example, when there is a router between a network and the security appliance.

==============================================

Full link -

http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/ip.html#wp1118237

Jon

Re: ASA Security Context and RIP Routing

enforcers — Thu, 11 Sep 2008 18:29:18 GMT

thank you

Re: ASA Security Context and RIP Routing

suschoud — Thu, 11 Sep 2008 18:42:56 GMT

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00809a7416.shtml

rip is not supported in multiple context.

Regards,

Sushil