topic Re: 5510 active-standby failover in Network Security

5510 active-standby failover

ksvy_ksvy — Mon, 11 Mar 2019 13:33:45 GMT

I have two new ASA 5510s, with 7.2(2)10 configured for active/standby failover.

due to ASA interface limitation/availability, I am using only one interface for both LAN-base and stateful failover:

interface Ethernet0/3

speed 100

duplex full

interface Ethernet0/3.2

description LAN Failover Interface

vlan 20

interface Ethernet0/3.3

description STATE Failover Interface

vlan 30

failover is working, but I'm concern that when I enter â€œshow failoverâ€ the firewalls don't see each other

any help?

thanks, kevin

Farrukh Haroon — Thu, 21 Aug 2008 02:04:23 GMT

First of all you don't need sub-interfaces if you share the Failover/Stateful interface(s). Just use Eth0/0.

Secondly is it possible to post the output of 'show failover? and if possible show run failover.

Regards

Farrukh

ksvy_ksvy — Thu, 21 Aug 2008 13:11:41 GMT

Farrukh, I messed and didn't use:

failover key xxxxx

once I entered the key, on both, sync' come right up and all works now

thanks, for responding

kevin

Farrukh Haroon — Thu, 21 Aug 2008 13:32:20 GMT

No problem, glad you have it working now.

Regards

Farrukh