topic Re: 7606 SPAN Issues in Network Security https://community.cisco.com/t5/network-security/7606-span-issues/m-p/460177#M91544 <HTML><HEAD></HEAD><BODY><P>When configuring monitor sessions, note the following information:</P><P>To tag the monitored traffic, you must configure the port to trunk unconditionally before you configure it as a destination.</P><P><A class="jive-link-custom" href="http://www.cisco.com/univercd/cc/td/doc/product/core/cis7600/software/122sx/swcg/span.htm" target="_blank">http://www.cisco.com/univercd/cc/td/doc/product/core/cis7600/software/122sx/swcg/span.htm</A></P></BODY></HTML> Thu, 06 Oct 2005 17:53:33 GMT smalkeric 2005-10-06T17:53:33Z 7606 SPAN Issues https://community.cisco.com/t5/network-security/7606-span-issues/m-p/460176#M91543 <P>Hello all,</P><P></P><P>I'm trying to configure a SPAN monitor session on a 7606 router. </P><P></P><P>interface GigabitEthernet3/7</P><P> description to IDS01 SPAN Port </P><P> no ip address</P><P> speed 1000</P><P> duplex full</P><P> switchport</P><P> switchport trunk allowed vlan 4,5</P><P> switchport mode trunk</P><P> spanning-tree portfast trunk</P><P></P><P>at this point my interface show up/up.</P><P></P><P>after I applied the below monitor session.</P><P></P><P>monitor session 2 source interface Po3</P><P>monitor session 2 filter vlan 4 - 5</P><P>monitor session 2 destination interface Gi3/7</P><P></P><P>My G3/7 show up/down. The IDS is plug into G3/7, showed up/down as well.</P><P></P><P>Would like to understand why i'm getting an interface of up/down.</P><P></P><P>OH, the 7606 is using SXD3.</P><P></P><P>Thank.</P><P></P> Sun, 10 Mar 2019 09:40:23 GMT https://community.cisco.com/t5/network-security/7606-span-issues/m-p/460176#M91543 sneou 2019-03-10T09:40:23Z Re: 7606 SPAN Issues https://community.cisco.com/t5/network-security/7606-span-issues/m-p/460177#M91544 <HTML><HEAD></HEAD><BODY><P>When configuring monitor sessions, note the following information:</P><P>To tag the monitored traffic, you must configure the port to trunk unconditionally before you configure it as a destination.</P><P><A class="jive-link-custom" href="http://www.cisco.com/univercd/cc/td/doc/product/core/cis7600/software/122sx/swcg/span.htm" target="_blank">http://www.cisco.com/univercd/cc/td/doc/product/core/cis7600/software/122sx/swcg/span.htm</A></P></BODY></HTML> Thu, 06 Oct 2005 17:53:33 GMT https://community.cisco.com/t5/network-security/7606-span-issues/m-p/460177#M91544 smalkeric 2005-10-06T17:53:33Z