topic Re: Access-list question in Network Security https://community.cisco.com/t5/network-security/access-list-question/m-p/967677#M918350 <HTML><HEAD></HEAD><BODY><P>Yes, that's correct.</P><P></P><P>You will need to apply the ACL to your outside interface -</P><P></P><P>access-group 101 in interface outside (as example)</P><P></P><P>Depending on your config, you may need to assign a static NAT to your server.</P><P></P><P>static (inside,outside) public.ip.address internal.ip.address netmask 255.255.255.255</P><P></P></BODY></HTML> Mon, 16 Jun 2008 13:26:10 GMT dgroscost 2008-06-16T13:26:10Z Access-list question https://community.cisco.com/t5/network-security/access-list-question/m-p/967676#M918349 <P>Hello,</P><P></P><P>We have a PIX 506 firewall and I need to allow a specific IP address, 141.157.129.77 to access a server inside the LAN on port #1999. I created a public IP address for the server but I am not so sure if the following command is correct. </P><P></P><P>access-list 101 permit tcp host 141.157.129.77 host â&#128;&#156;public ip address of our serverâ&#128;&#157; eq 1999</P><P></P><P>Thank you</P><P></P> Mon, 11 Mar 2019 12:59:49 GMT https://community.cisco.com/t5/network-security/access-list-question/m-p/967676#M918349 h-kholghi 2019-03-11T12:59:49Z Re: Access-list question https://community.cisco.com/t5/network-security/access-list-question/m-p/967677#M918350 <HTML><HEAD></HEAD><BODY><P>Yes, that's correct.</P><P></P><P>You will need to apply the ACL to your outside interface -</P><P></P><P>access-group 101 in interface outside (as example)</P><P></P><P>Depending on your config, you may need to assign a static NAT to your server.</P><P></P><P>static (inside,outside) public.ip.address internal.ip.address netmask 255.255.255.255</P><P></P></BODY></HTML> Mon, 16 Jun 2008 13:26:10 GMT https://community.cisco.com/t5/network-security/access-list-question/m-p/967677#M918350 dgroscost 2008-06-16T13:26:10Z