topic Re: Can't add Firepower Licenses to ASA Firepower Module. in Network Security

Can't add Firepower Licenses to ASA Firepower Module.

gamoore — Fri, 21 Feb 2020 15:47:02 GMT

Hi,

I just loaded my Firepower Licenses to my FMC, Protection/Control, Malware, and URL. But, when I try to add them to the Firepower Module in my ASA5506 the check boxes to enable the license are grayed out.

I've deleted the Device and re-added it to the FMC a couple of times and the issue remain.

Re: Can't add Firepower Licenses to ASA Firepower Module.

Marvin Rhoads — Fri, 18 May 2018 04:34:14 GMT

Can you share a screenshot of the FMC Classic licenses page? If the licenses are present there they should be available to assign to your device.

Re: Can't add Firepower Licenses to ASA Firepower Module.

gamoore — Fri, 18 May 2018 17:21:43 GMT

Re: Can't add Firepower Licenses to ASA Firepower Module.

Marvin Rhoads — Sat, 19 May 2018 00:28:26 GMT

The licenses in your screenshot are for ‘VirtualDevice64bit’.

Those are for NGIPSv and cannot be used with Firepower service module on an ASA. The license type must match the target sensor as they are priced differently and use different SKUs.

Re: Can't add Firepower Licenses to ASA Firepower Module.

gamoore — Sat, 19 May 2018 02:47:07 GMT

Thanks Marvin.

Re: Can't add Firepower Licenses to ASA Firepower Module.

Marvin Rhoads — Sun, 20 May 2018 07:05:52 GMT

You're welcome. Please rate if it answered your question.