topic Re: NM-CIDS-K9 on 2821 in Network Security https://community.cisco.com/t5/network-security/nm-cids-k9-on-2821/m-p/593438#M92870 <HTML><HEAD></HEAD><BODY><P>The issue may be due to the cabels or the interfaces that are connected to sensor may be down due to hardware problem. Check the hardware compnonet of the IDS sensor.</P></BODY></HTML> Wed, 26 Jul 2006 17:24:40 GMT amritpatek 2006-07-26T17:24:40Z NM-CIDS-K9 on 2821 https://community.cisco.com/t5/network-security/nm-cids-k9-on-2821/m-p/593437#M92869 <P>Hi, </P><P></P><P>I installed a NM-CIDS-K9 Module into my 2821 router running 12.4.8 (C2800NM-ADVSECURITYK9-M). My IDS module is running 5.0(2)S152.0. The issue I have is that the Interface IDS-Sensor 1/0 of my router is going up and down every 10 seconds. I configured ip cef and followed the Cisco Manual, but I cannot figure out why this happen. Is this a IOS bug or do I need to upgrade the IDS ?</P><P></P><P>Any help would be appreciated !</P><P></P><P>Francois</P> Sun, 10 Mar 2019 10:06:51 GMT https://community.cisco.com/t5/network-security/nm-cids-k9-on-2821/m-p/593437#M92869 buntschu 2019-03-10T10:06:51Z Re: NM-CIDS-K9 on 2821 https://community.cisco.com/t5/network-security/nm-cids-k9-on-2821/m-p/593438#M92870 <HTML><HEAD></HEAD><BODY><P>The issue may be due to the cabels or the interfaces that are connected to sensor may be down due to hardware problem. Check the hardware compnonet of the IDS sensor.</P></BODY></HTML> Wed, 26 Jul 2006 17:24:40 GMT https://community.cisco.com/t5/network-security/nm-cids-k9-on-2821/m-p/593438#M92870 amritpatek 2006-07-26T17:24:40Z