topic Re: Re-convergence does not work on FTD in Network Security https://community.cisco.com/t5/network-security/re-convergence-does-not-work-on-ftd/m-p/3985891#M935240 <P>I'm informed that this is per design. Case closed.</P> Tue, 19 Nov 2019 13:45:27 GMT frodestra 2019-11-19T13:45:27Z Re-convergence does not work on FTD https://community.cisco.com/t5/network-security/re-convergence-does-not-work-on-ftd/m-p/3985802#M935239 <P>Hi Forum,</P><P>&nbsp;</P><P>we have a pair of FTD2140 running patch 6.4.0.4 in HA setup. Default HA timer are used. Re-convergence does not happen after a failover. All interfaces are in "normal" status when doing "show high-availability config" from CLI. Is this behavior per design? I was expecting re-convergence when interfaces are back up again.</P><P>&nbsp;</P><P>Thanks,</P><P>Frode</P> Fri, 21 Feb 2020 17:42:08 GMT https://community.cisco.com/t5/network-security/re-convergence-does-not-work-on-ftd/m-p/3985802#M935239 frodestra 2020-02-21T17:42:08Z Re: Re-convergence does not work on FTD https://community.cisco.com/t5/network-security/re-convergence-does-not-work-on-ftd/m-p/3985891#M935240 <P>I'm informed that this is per design. Case closed.</P> Tue, 19 Nov 2019 13:45:27 GMT https://community.cisco.com/t5/network-security/re-convergence-does-not-work-on-ftd/m-p/3985891#M935240 frodestra 2019-11-19T13:45:27Z