topic Re: IKE Does Not Start in Network Security https://community.cisco.com/t5/network-security/ike-does-not-start/m-p/1001897#M937419 <HTML><HEAD></HEAD><BODY><P>Hi,</P><P></P><P>It starts working after a reload.</P><P></P><P>Thanks for your response</P></BODY></HTML> Thu, 22 May 2008 19:20:14 GMT Chuan Liu 2008-05-22T19:20:14Z IKE Does Not Start https://community.cisco.com/t5/network-security/ike-does-not-start/m-p/1001895#M937417 <P>Hi,</P><P></P><P>I have an ASA5510. When I put the command 'crypto map MAP 20 set peer a.b.c.d', an error message "[IKEv1]: Ignoring msg to mark SA with specified coordinates &lt;MAP, 20&gt; dead" comes out. What does this mean?</P><P>When I turned out debug crypto isakmp 127, no messages come out.</P><P>How can I start IKE?</P><P></P><P>Thanks in advance.</P> Mon, 11 Mar 2019 12:48:03 GMT https://community.cisco.com/t5/network-security/ike-does-not-start/m-p/1001895#M937417 Chuan Liu 2019-03-11T12:48:03Z Re: IKE Does Not Start https://community.cisco.com/t5/network-security/ike-does-not-start/m-p/1001896#M937418 <HTML><HEAD></HEAD><BODY><P>Hi,</P><P> I am not sure about your full configuration, but if you want to enable ISAKMP on a specific intrface use the command: </P><P> </P><P>Crypto isakmp enable interface_name</P><P></P><P> The ISAKMP should start when you define this, if this is not the case, post your config, and make some debugging, for isakmp and ipsec.</P><P></P><P>regards</P></BODY></HTML> Thu, 22 May 2008 04:24:07 GMT https://community.cisco.com/t5/network-security/ike-does-not-start/m-p/1001896#M937418 alanajjar 2008-05-22T04:24:07Z Re: IKE Does Not Start https://community.cisco.com/t5/network-security/ike-does-not-start/m-p/1001897#M937419 <HTML><HEAD></HEAD><BODY><P>Hi,</P><P></P><P>It starts working after a reload.</P><P></P><P>Thanks for your response</P></BODY></HTML> Thu, 22 May 2008 19:20:14 GMT https://community.cisco.com/t5/network-security/ike-does-not-start/m-p/1001897#M937419 Chuan Liu 2008-05-22T19:20:14Z