topic Re: CRC errors on outside interface in Network Security https://community.cisco.com/t5/network-security/crc-errors-on-outside-interface/m-p/945079#M937745 <HTML><HEAD></HEAD><BODY><P>Check the duplex/speed settings on both side of the connections.</P><P></P><P>This link might help, could rule out config issues if nothing else...</P><P><A class="jive-link-custom" href="http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a008009491c.shtml#showinterface" target="_blank">http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a008009491c.shtml#showinterface</A></P></BODY></HTML> Wed, 14 May 2008 14:47:15 GMT d.donnelly 2008-05-14T14:47:15Z CRC errors on outside interface https://community.cisco.com/t5/network-security/crc-errors-on-outside-interface/m-p/945078#M937744 <P>I've noticed a large amt of CRC errors on the outside int of a Pix 515e. We have replaced the cable but the errors are still accumulating; about 48k in the last 24 hours. Bad interface card, do you think?</P> Mon, 11 Mar 2019 12:44:58 GMT https://community.cisco.com/t5/network-security/crc-errors-on-outside-interface/m-p/945078#M937744 paulc 2019-03-11T12:44:58Z Re: CRC errors on outside interface https://community.cisco.com/t5/network-security/crc-errors-on-outside-interface/m-p/945079#M937745 <HTML><HEAD></HEAD><BODY><P>Check the duplex/speed settings on both side of the connections.</P><P></P><P>This link might help, could rule out config issues if nothing else...</P><P><A class="jive-link-custom" href="http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a008009491c.shtml#showinterface" target="_blank">http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a008009491c.shtml#showinterface</A></P></BODY></HTML> Wed, 14 May 2008 14:47:15 GMT https://community.cisco.com/t5/network-security/crc-errors-on-outside-interface/m-p/945079#M937745 d.donnelly 2008-05-14T14:47:15Z Re: CRC errors on outside interface https://community.cisco.com/t5/network-security/crc-errors-on-outside-interface/m-p/945080#M937749 <HTML><HEAD></HEAD><BODY><P>Thanks, that was it. I reset the int to auto. Funny thing is that it can't be done thru PDM if failover is enabled. I had to do it thru cli.</P></BODY></HTML> Wed, 14 May 2008 15:24:56 GMT https://community.cisco.com/t5/network-security/crc-errors-on-outside-interface/m-p/945080#M937749 paulc 2008-05-14T15:24:56Z