Remote Client Cant Access

wasiimcisco — Mon, 11 Mar 2019 12:43:28 GMT

Client is able to connect without any problem, but client not able to ping or connect with any network device.

In VPN session i can see bytes send and receive. My LAN-2-LAN tunnles are working fine without any problem.

No firewall involoved in the path between the concentrator and desired server 172.28.31.171.

Both connected on same switch but different VLAN. Inter VLAN routing is working and both are able to ping.

ONly remote access client 172.28.31.128/248 is not able to reach anywhere.

Core switch routing table

ip route 172.28.0.0 255.255.0.0 172.28.31.68

ip route 172.28.0.0 255.255.224.0 172.28.31.77

ip route 172.28.31.128 255.255.255.248 172.28.31.92

ip route 172.28.32.50 255.255.255.255 172.28.31.92

ip route 172.29.0.0 255.255.0.0 172.28.31.68

Concentrator routing table

172.28.31.160 255.255.255.224 via 172.28.31.91

172.28.92.0 255.255.255.0 via 172.28.31.91

172.29.0.0 255.255.0.0 via 172.28.31.91

192.168.0.0 255.255.0.0 via 172.28.31.91

172.28.31.170 255.255.255.255 via 172.28.31.91

Split tunnel is enable for

172.28.31.88/0.0.0.7

192.168.0.0/0.0.255.255

172.29.0.0/0.0.255.255

172.28.92.0/0.0.0.255

172.28.31.170/0.0.0.0

172.28.31.171/0.0.0.0

Re: Remote Client Cant Access

smahbub — Fri, 16 May 2008 17:26:17 GMT

refer to the troubleshooting guide for all vpn problems present in the link given:

remco.gussen — Wed, 21 May 2008 07:53:31 GMT

Did you create a NAT 0 (excemption) rule ?