topic static nat in Network Security https://community.cisco.com/t5/network-security/static-nat/m-p/991872#M940653 <P>Is there a way to map 2 different inside addresses to a common outside address via a static nat command. Other firewalls I have worked with, particularly Netscreen, allows me to create two mapped addresses to the same host. I am trying to achieve same on the ASA but receive error about the duplication.</P> Mon, 11 Mar 2019 12:20:04 GMT alackraj 2019-03-11T12:20:04Z static nat https://community.cisco.com/t5/network-security/static-nat/m-p/991872#M940653 <P>Is there a way to map 2 different inside addresses to a common outside address via a static nat command. Other firewalls I have worked with, particularly Netscreen, allows me to create two mapped addresses to the same host. I am trying to achieve same on the ASA but receive error about the duplication.</P> Mon, 11 Mar 2019 12:20:04 GMT https://community.cisco.com/t5/network-security/static-nat/m-p/991872#M940653 alackraj 2019-03-11T12:20:04Z Re: static nat https://community.cisco.com/t5/network-security/static-nat/m-p/991873#M940654 <HTML><HEAD></HEAD><BODY><P>Im not aware that you can map two or more inside hosts addresses to a single global address in ASA via static nat for outbound connections. You can map 2 or more global IP addresses to a single inside host via policy-based nat for inbound connections. Are you sure that this is what you are trying to accomplish? perhaps you meant 2 global IPs mapped to single inside host to allow inbound connections to same host inside using 2 global IPs? if your post is correct then it is not possible to map single global IP to two different inside addresses through static nat.</P><P></P><P></P><P> </P><P></P></BODY></HTML> Thu, 20 Mar 2008 03:29:22 GMT https://community.cisco.com/t5/network-security/static-nat/m-p/991873#M940654 JORGE RODRIGUEZ 2008-03-20T03:29:22Z