topic Re: Monitoring Firepower with FTD CPU load in Network Security

Monitoring Firepower with FTD CPU load

TomKaspar — Fri, 21 Feb 2020 17:12:58 GMT

Hi,

do you somebody know, how I can monitor FTD all CPU load? I know, that FTD has 2 level CPU (LINA and SNORT). I need monitor CPU load HW appliance.

If snort is high load, this not mean, that FW is overloaded.

Thank you for your advise.

Tomas

Re: Monitoring Firepower with FTD CPU load

Hesham Noaman — Thu, 13 Jun 2019 18:53:04 GMT

Hi,

So far for FTD, There is no unified display for CPU load, as far as I know you can check on FMC The CPU load of the appliance.

SNMP walking of CPU load for FTD is not available yet, there an enhancement request for it, to be able to walk the data as it is in Sourcefire 7/8000 Apliances.

If your mgmt is on-box FDM, wait for 6.5 release, It Will have accurate data read from the GUI.

-Hesham

Re: Monitoring Firepower with FTD CPU load

#Mat — Thu, 13 Jun 2019 20:25:04 GMT

Hi! As said @Hesham Noaman, if you have FMC, you can check them from Health Policy.

https://www.cisco.com/c/en/us/td/docs/security/firepower/60/configuration/guide/fpmc-config-guide-v60/Health_Monitoring.html#ID-2227-00000049

Regards.-