topic PBR on FTD in Network Security

PBR on FTD

alimaanna — Fri, 21 Feb 2020 17:10:28 GMT

I configured route-map on FMC, then I configured a text object as a next hop for the PBR.

I used this object in the Flex configuration, for the PBR, and everything was fine, after deployment I checked the configuration on the FTD, but something weird happens, the configuration has been applied as below

route-map Test_PBR permit 10
match ip address PBR_ACL
set ip next-hop peer-address

so I checked the deployment history, and error appears in the deploy transcriot

ERROR: Peer-address and specific IP address can not be mixed.

any help.

Thank you all in advanced.

Re: PBR on FTD

Sheraz.Salim — Tue, 28 May 2019 14:00:23 GMT

check this link similar issue.

https://community.cisco.com/t5/firepower/pbr-on-ftd/td-p/3327116

https://www.youtube.com/watch?v=lakHhw9CR5Y

Re: PBR on FTD

alimaanna — Tue, 28 May 2019 14:39:58 GMT

Dear Sheraz.Salim,

This is another problem and I already checked the attached video, all configuration is done like the video but the output on the device is different.

Thank you in all cases.