topic Re: PIX change management software in Network Security

PIX change management software

ahmad82pkn — Fri, 21 Feb 2020 11:49:21 GMT

Hi, i have Cisco works LMS3.0,

i have added all routers switches, and after every 24 hours, all changes to my routers switches, i get that via email,

but i dont see any change report of cisco pix firewall.

dont LMS3.0 support firewall changes ? am i missing some thing? or i need some other software to do that?

Re: PIX change management software

Farrukh Haroon — Tue, 15 Dec 2009 19:52:25 GMT

The PIX/ASA etc. firewalls are supported. We have setup RME to report changes in one of our customer's FWSM blade.

This is also mentioned on the following link: (Just search for 'Pix' on the page)

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/3.1/device_support/table/lms31sdt.html

Regards

Farrukh

Re: PIX change management software

ahmad82pkn — Tue, 15 Dec 2009 23:32:55 GMT

Thank you for the information, But i dont get change report , though devices are added in same way as of Routers,

Do i need to do any additional confoguration on firewall, except SNMP string and specifying IP address of server running LMS and its interface name inside in my case?

in my PIX i have this confoguration, router confoguration change report comes fine, with same set of information configured in router/switches.

snmp-server host inside x.x.x.x community abcd

snmp-server community abcd

Re: PIX change management software

Farrukh Haroon — Wed, 16 Dec 2009 06:17:24 GMT

Do one thing, go to the Device Center >> Select the 'Firewall' and then click on 'View Config' Is RME collecting any

configs at all for your firewall? You can also check this from RME directly.

Regards

Farrukh