topic Re: vpn client does not ping to internal network in Network Security

vpn client does not ping to internal network

m.naresh — Fri, 21 Feb 2020 11:30:38 GMT

i have configured pix 515e for vpn client. i then installed cisco vpn client in my pc. now if i connect my pc to pix using the cisco vpn client ,i get connected and pc is assisgned a ip address from the pool i have configured in pix.my issue is : when i ping from pix to the pc it pings fine,but from the pc it does not ping to pix inside interface or pix inside network.

Please help

Re: vpn client does not ping to internal network

mvsheik123 — Fri, 12 Jun 2009 12:59:55 GMT

Hi,

if you are using split tunneling, make sure the ACL is configured properly. here is helpful link..

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080702999.shtml

Also, make sure PIX has routes to internal networks and internal networks hit PIX to reach the VPN cleint subnet.

hth

Re: vpn client does not ping to internal network

m.naresh — Mon, 15 Jun 2009 08:55:13 GMT

Hi,

the link you provided was very useful.

But still i am not able to connect.

In the vpnclient log i see the following message:

AddRoute failed to add a route: code 87

Your help will be appreciated.

Regards

Arul

Re: vpn client does not ping to internal network

mvsheik123 — Mon, 15 Jun 2009 13:14:34 GMT

Hi,

This error looks like more from your client end. Try to 'google' for solution. I would also try from PC connected directly to internet or wired connection (if your testing PC using wireless). Post the PIX head end configs here, Gurus may be able to help (if there is any head end config issues).

hth

** Rate the useful posts**

Re: vpn client does not ping to internal network

m.naresh — Wed, 17 Jun 2009 17:00:21 GMT

You are correct.

After installing the vpn client from 4.x to 5.x and after making few changes in pix config the issue was resolved.

Thanks for your help