topic IS POSSIBLE USE ANYCONNECT FOR REMOTE ACCESS? in Network Security

IS POSSIBLE USE ANYCONNECT FOR REMOTE ACCESS?

leandro.candido — Fri, 21 Feb 2020 11:28:49 GMT

I need of a client for remote access to use in my MAC and WINDOWDOS 64 BIT.

I have searched this, but I did understand that this client there is no for MAC and Win 64-bit just anyconnect has supported this.

Do you know if possible use anyconnect for remote acess vpn? If yes, how is made the anyconnect client configuration?

Thanks

Re: IS POSSIBLE USE ANYCONNECT FOR REMOTE ACCESS?

Collin Clark — Tue, 26 May 2009 12:47:56 GMT

Anyconnect is the next generation of VPN Client, so yes, you can use it for remote access vpn. The client configuration is very easy. You enter the the hostname of the VPN, then when the VPN is established, you enter your username, password, and group (if necessary).

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080975e83.shtml

Hope that helps.

Re: IS POSSIBLE USE ANYCONNECT FOR REMOTE ACCESS?

leandro.candido — Tue, 26 May 2009 13:10:34 GMT

I did understand, but the problem is that we have one tunnel for remote access e other tunnerl for ssl vpn.

How use the anyconnect for permit connection in remote access tunnel?

Thanks

Re: IS POSSIBLE USE ANYCONNECT FOR REMOTE ACCESS?

Farrukh Haroon — Tue, 26 May 2009 13:17:35 GMT

AFAIK, Cisco is planning to integrate both the IPSEC and SSL clients into one, but till now both of them are separate.

So you cannot use Anyconnect for IPSEC connections.

Regards

Farrukh