topic Re: Setting cloc on IPS in Network Security https://community.cisco.com/t5/network-security/setting-cloc-on-ips/m-p/464534#M95400 <HTML><HEAD></HEAD><BODY><P>What model sensor is this? The IDSM2, NM-CIDS, and SSM sensors doe not have a "clock set" command because they slave off of their host. If it is an IDSM2 then it gets its time from the switch (you would have to set time on the switch). Also, after making changes to the offsets (local and/or summertime) you will need to reboot the sensor to see the correct time.</P></BODY></HTML> Tue, 06 Sep 2005 15:44:38 GMT jamesand 2005-09-06T15:44:38Z Setting cloc on IPS https://community.cisco.com/t5/network-security/setting-cloc-on-ips/m-p/464533#M95399 <P>Folks,</P><P> I do not see any option of setting clock in the new IPS CLI. I used the setup command and adjusted the time zone to EST and 5 hours offset, now it is showing in incorrect time??</P><P></P><P>Thanks</P> Sun, 10 Mar 2019 09:37:30 GMT https://community.cisco.com/t5/network-security/setting-cloc-on-ips/m-p/464533#M95399 NAVIN PARWAL 2019-03-10T09:37:30Z Re: Setting cloc on IPS https://community.cisco.com/t5/network-security/setting-cloc-on-ips/m-p/464534#M95400 <HTML><HEAD></HEAD><BODY><P>What model sensor is this? The IDSM2, NM-CIDS, and SSM sensors doe not have a "clock set" command because they slave off of their host. If it is an IDSM2 then it gets its time from the switch (you would have to set time on the switch). Also, after making changes to the offsets (local and/or summertime) you will need to reboot the sensor to see the correct time.</P></BODY></HTML> Tue, 06 Sep 2005 15:44:38 GMT https://community.cisco.com/t5/network-security/setting-cloc-on-ips/m-p/464534#M95400 jamesand 2005-09-06T15:44:38Z