https://community.cisco.com/t5/network-security/verifying-split-tunnel-from-the-end-client/m-p/3394132#M956089 URL access is a mix of routing and firewall access (all in one).<BR />I wouldn't expect any other "relevant config" as long as routing looks good on the client side. Tue, 05 Jun 2018 09:07:41 GMT Florin Barhala 2018-06-05T09:07:41Z https://community.cisco.com/t5/network-security/verifying-split-tunnel-from-the-end-client/m-p/3392667#M956088 <P>Hi All ,&nbsp;</P> <P>How to verify a URL after adding the networks to the split tunnel from the end client . I have verified by seeing the routes in the end client . Is there any other way to check from traceroute or route print .</P> <P>route print looks the same for all websites . What would be difference we need to observe .</P> <P>&nbsp;</P> <P>Thanks in advance ,&nbsp;</P> <P>NS</P> <P>&nbsp;</P> Fri, 21 Feb 2020 15:50:17 GMT https://community.cisco.com/t5/network-security/verifying-split-tunnel-from-the-end-client/m-p/3392667#M956088 gnanavel.ns 2020-02-21T15:50:17Z https://community.cisco.com/t5/network-security/verifying-split-tunnel-from-the-end-client/m-p/3394132#M956089 URL access is a mix of routing and firewall access (all in one).<BR />I wouldn't expect any other "relevant config" as long as routing looks good on the client side. Tue, 05 Jun 2018 09:07:41 GMT https://community.cisco.com/t5/network-security/verifying-split-tunnel-from-the-end-client/m-p/3394132#M956089 Florin Barhala 2018-06-05T09:07:41Z