topic Re: ASA5510 - Couple issues. in Network Security https://community.cisco.com/t5/network-security/asa5510-couple-issues/m-p/832166#M958135 <HTML><HEAD></HEAD><BODY><P>I would start by upgrading to at least v. 7.2.2.</P><P></P><P>Check your speed duplex on outside interface. Hardcode to 100 full if necessary.</P><P></P><P>Next your acl doesn't look right for sqlnet. I believe you want this...</P><P></P><P>access-list outsidein extended permit tcp host x.x.x.x host 192.168.4.29 eq sqlnet</P></BODY></HTML> Fri, 21 Dec 2007 15:20:53 GMT acomiskey 2007-12-21T15:20:53Z ASA5510 - Couple issues. https://community.cisco.com/t5/network-security/asa5510-couple-issues/m-p/832165#M958133 <P>I am new to Cisco products and have a couple of issues. I have installed two 5510's and in both places the internet is now EXTREMELY slow. A Cisco tech got into one of them and said that everything looked fine. I am hoping that someone here can help me out. I am also trying to open the sqlnet port, but the state cannot seem to get in. I don't even see his IP come in the log but he did confirm the IP that I gave him. Here is the config. Thanks in advance.</P><P></P><P></P><P></P><P> </P><P></P> Wed, 13 Mar 2019 00:53:58 GMT https://community.cisco.com/t5/network-security/asa5510-couple-issues/m-p/832165#M958133 markisaac 2019-03-13T00:53:58Z Re: ASA5510 - Couple issues. https://community.cisco.com/t5/network-security/asa5510-couple-issues/m-p/832166#M958135 <HTML><HEAD></HEAD><BODY><P>I would start by upgrading to at least v. 7.2.2.</P><P></P><P>Check your speed duplex on outside interface. Hardcode to 100 full if necessary.</P><P></P><P>Next your acl doesn't look right for sqlnet. I believe you want this...</P><P></P><P>access-list outsidein extended permit tcp host x.x.x.x host 192.168.4.29 eq sqlnet</P></BODY></HTML> Fri, 21 Dec 2007 15:20:53 GMT https://community.cisco.com/t5/network-security/asa5510-couple-issues/m-p/832166#M958135 acomiskey 2007-12-21T15:20:53Z Re: ASA5510 - Couple issues. https://community.cisco.com/t5/network-security/asa5510-couple-issues/m-p/832167#M958137 <HTML><HEAD></HEAD><BODY><P>To upgrade from version 7.0(6) to 7.2 I have to first go to 7.1, correct? I am trying to figure out how to do that. The "upgrade software" is not an option under tools. I have downloaded all the updates and loaded them onto the unit. Is it a matter of just removing the asa706-k8.bin file? If I do that will the Cisco just pick up the next boot image or do I need to load asa711-k8.bin somehow?</P></BODY></HTML> Fri, 21 Dec 2007 17:24:32 GMT https://community.cisco.com/t5/network-security/asa5510-couple-issues/m-p/832167#M958137 markisaac 2007-12-21T17:24:32Z