topic Re: FMC deployment error(Please modify the description...) in Network Security

FMC deployment error(Please modify the description...)

Mohammed Al-odhari — Fri, 21 Feb 2020 15:44:37 GMT

Dear all,

I`m having FMC 6.2.3 virtual in addition to two 2120 ver 6.2.3. I cant configure the HA because of the Deployment pending (Please modify the description of your Access Policy).

I modified it but no worthy.

Please refer to the 3 photos attached (change it to .zip) and help.

Thanks for cooperation.

regards,

Re: FMC deployment error(Please modify the description...)

Marius Gunnerud — Tue, 08 May 2018 18:01:04 GMT

What you posted doesn't include the actual policies you have configured. This is where the issue is. Did you migrate from an ASA? I have seen this happen when using the migration tool when migrating from ASA to FTD.

The issue is that the name and/or description you have given an ACP entry doesn't meet the character requirements. Check the ACP entries and modify them then try again.

Re: FMC deployment error(Please modify the description...)

Mohammed Al-odhari — Wed, 09 May 2018 07:05:38 GMT

Thanks Marius for your replay.

No i dont migrate from ASA. i have 2 firepower applience 2120 in which i configure on them the following:

>configure manager add 172.31.99.30 CISCO123

Then in the FMC i added them successfully.

Then any configuration i want to do or create HA, it replies me with the deployment error.

Where exactly the to edit the name or description of the ACP.??

Thanks again.

regards,

Re: FMC deployment error(Please modify the description...)

takk — Thu, 23 Aug 2018 02:38:38 GMT

Here, take a look at picture.
I had similar issue with ACP deployment. In my case it was spase character exactly in description field. After removing it, error msg is gone.

Re: FMC deployment error(Please modify the description...)

manuel.toro — Wed, 29 Aug 2018 03:39:26 GMT

Works for me too. thanks 🙂