https://community.cisco.com/t5/network-security/cannot-use-nat-command-in-packet-tracer/m-p/3360526#M963584 <P>You could try using GNS3 or VIRL which have all the commands available on real devices.</P> <P>&nbsp;</P> <P>HTH</P> <P>Bogdan</P> Wed, 04 Apr 2018 15:46:23 GMT Bogdan Nita 2018-04-04T15:46:23Z https://community.cisco.com/t5/network-security/cannot-use-nat-command-in-packet-tracer/m-p/3360432#M963583 <P>I'm using packet tracer 7.1.1 and the "nat" command doesn't exist in config mode. It looks like I can use network object nat in command mode, but thats not what I need. I need to make a static no nat command like:</P> <P># nat (inside,outside) source static 192.168.1.0 192.168.1.0 destination static 192.168.2.0 192.168.2.0&nbsp;no-proxy-arp route-lookup</P> <P>&nbsp;</P> <P>Any ideas? Thanks.</P> Fri, 21 Feb 2020 15:35:53 GMT https://community.cisco.com/t5/network-security/cannot-use-nat-command-in-packet-tracer/m-p/3360432#M963583 tolinrome tolinrome 2020-02-21T15:35:53Z https://community.cisco.com/t5/network-security/cannot-use-nat-command-in-packet-tracer/m-p/3360526#M963584 <P>You could try using GNS3 or VIRL which have all the commands available on real devices.</P> <P>&nbsp;</P> <P>HTH</P> <P>Bogdan</P> Wed, 04 Apr 2018 15:46:23 GMT https://community.cisco.com/t5/network-security/cannot-use-nat-command-in-packet-tracer/m-p/3360526#M963584 Bogdan Nita 2018-04-04T15:46:23Z