topic Lost access after enabling interface. in Network Security https://community.cisco.com/t5/network-security/lost-access-after-enabling-interface/m-p/341170#M97434 <P>Hi I have an IDS 4215. I was just working on the initial setup. (I'm not very good with this).</P><P>I managed to create the accounts and get connectivity from 4 workstations. Tested connection and everything worked.(ping, telnet ssh)</P><P></P><P>I was logged in through the GUI interface <A class="jive-link-custom" href="https://ip_address" target="_blank">https://ip_address</A></P><P></P><P>The minute I went to Configuration &gt; Sensing Engine &gt; Interfaces and select enable...boom lost all connectivity. I can console into the device...I can't ping anything from the IDS... I run the setup and see the correct ip and gateway...but no access... how can I regain access to this IDS??</P><P>Thanks</P> Sun, 10 Mar 2019 09:13:07 GMT Randa11Villalobos 2019-03-10T09:13:07Z Lost access after enabling interface. https://community.cisco.com/t5/network-security/lost-access-after-enabling-interface/m-p/341170#M97434 <P>Hi I have an IDS 4215. I was just working on the initial setup. (I'm not very good with this).</P><P>I managed to create the accounts and get connectivity from 4 workstations. Tested connection and everything worked.(ping, telnet ssh)</P><P></P><P>I was logged in through the GUI interface <A class="jive-link-custom" href="https://ip_address" target="_blank">https://ip_address</A></P><P></P><P>The minute I went to Configuration &gt; Sensing Engine &gt; Interfaces and select enable...boom lost all connectivity. I can console into the device...I can't ping anything from the IDS... I run the setup and see the correct ip and gateway...but no access... how can I regain access to this IDS??</P><P>Thanks</P> Sun, 10 Mar 2019 09:13:07 GMT https://community.cisco.com/t5/network-security/lost-access-after-enabling-interface/m-p/341170#M97434 Randa11Villalobos 2019-03-10T09:13:07Z Re: Lost access after enabling interface. https://community.cisco.com/t5/network-security/lost-access-after-enabling-interface/m-p/341171#M97437 <HTML><HEAD></HEAD><BODY><P>can you reboot it? see if that helps. what message you get when you try to telnet?</P><P></P><P></P></BODY></HTML> Wed, 05 Jan 2005 18:57:21 GMT https://community.cisco.com/t5/network-security/lost-access-after-enabling-interface/m-p/341171#M97437 nkhawaja 2005-01-05T18:57:21Z