https://community.cisco.com/t5/network-security/check-dscp-value-in-fmc-or-ftd-firewall/m-p/3864944#M990531 <P>Hi</P> <P>&nbsp;</P> <P>I believe there are no ways to see it live.</P> <P>You can use the packet capture feature and then see all qos tags.&nbsp;</P> <P>&nbsp;</P> <P>Audi you can configure a netflow and send them to a server to analyse the packet.</P> Thu, 30 May 2019 04:17:41 GMT Francesco Molino 2019-05-30T04:17:41Z https://community.cisco.com/t5/network-security/check-dscp-value-in-fmc-or-ftd-firewall/m-p/3864405#M990530 <P>Dear ALL,</P><P>&nbsp;</P><P>We have two sites, the IP-PBX main unit is installed on HQ, and the branch's IP-phone is connected to HQ via L2 leaseline, we had set the DSCP value (which is connected to IP-phone) in the Cisco2960 switch port.</P><P>In now, Can we check&nbsp; the DSCP value by the FMC or FTD CLI mode?</P><P>&nbsp;</P><P>FMC Version: 6.3.0</P><P>FTD model: ASA 5508-X 6.3.0</P><P>&nbsp;</P><P>&nbsp;</P><P>Support</P> Fri, 21 Feb 2020 17:10:36 GMT https://community.cisco.com/t5/network-security/check-dscp-value-in-fmc-or-ftd-firewall/m-p/3864405#M990530 Support ACME 2020-02-21T17:10:36Z https://community.cisco.com/t5/network-security/check-dscp-value-in-fmc-or-ftd-firewall/m-p/3864944#M990531 <P>Hi</P> <P>&nbsp;</P> <P>I believe there are no ways to see it live.</P> <P>You can use the packet capture feature and then see all qos tags.&nbsp;</P> <P>&nbsp;</P> <P>Audi you can configure a netflow and send them to a server to analyse the packet.</P> Thu, 30 May 2019 04:17:41 GMT https://community.cisco.com/t5/network-security/check-dscp-value-in-fmc-or-ftd-firewall/m-p/3864944#M990531 Francesco Molino 2019-05-30T04:17:41Z