topic Re: Does 9300X platforms support SDA border function? in Software-Defined Access (SD-Access)

Does 9300X platforms support SDA border function?

Madura Malwatte — Wed, 07 Sep 2022 00:45:08 GMT

Does the new 9300X platforms support co-located border/control plane function in SDA?

This doc mentions it supports in control plane node scale table, but no mention in the table below it for border scale.

https://www.cisco.com/c/en/us/products/collateral/cloud-systems-management/dna-center/nb-06-dna-center-data-sheet-cte-en.html#SDAccessplatformscale

Refer to:

Table 7. Cisco SD-Access control plane node scale

and

Table 8. Cisco SD-Access border node scale

Re: Does 9300X platforms support SDA border function?

jedolphi — Wed, 07 Sep 2022 05:41:04 GMT

Hi Madura, yes, 9300X supported in all roles listed in compatibility matrix -> https://cs.co/sda-compatibility-matrix . Yes BN+CP is supported. Looks like 9300X is shown in data sheet table 7 but not table 8. This is an error I'll request to be corrected. For scale please proceed on the understanding 9300X is same as 9300. Thanks, Jerome

Re: Does 9300X platforms support SDA border function?

Madura Malwatte — Wed, 07 Sep 2022 05:57:57 GMT

Hi Jerome,

Great thanks for confirming. I forgot to check the compatibility matrix!

Re: Does 9300X platforms support SDA border function?

balaji.bandi — Wed, 07 Sep 2022 15:06:21 GMT

Look at Fabirc in box :

https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/cisco-sda-design-guide.html#FabricinaBox