SD Access port assignment

KevinR99 — Tue, 10 Sep 2024 10:13:33 GMT

When I try to assign ports to address pools in SD Access not knowing that the device is offline it fails as expected but in the Port assignment area of DNAC it maintains the intended port assignment. How do we ensure this is then pushed out to the device when it comes back online? I resolved an issue with an Edge switch and then checked the port assignment and it didn't update. I also tried to Resync the device and again it didn't update. So the device and the DNAC port assignement area are now not matching. The only way I could force the update was to select all the ports I tried to config and "Edit Configuration" and I just added a space to the description to fake a change then deployed. That pushed out the config.

Smillarly, if I make fabric changes, such as adding anycast gateways, whilst devices are offline do these additions get pushed out automatically? If not how do I ensure the changes get pushed to devices when they come back online ?

Thanks, Kev

Re: SD Access port assignment

Andrii Oliinyk — Tue, 10 Sep 2024 11:50:57 GMT

not sure how u got it. in our LAB it works as expected independently on port status

Re: SD Access port assignment

Preston Chilcote — Tue, 10 Sep 2024 14:58:02 GMT

Perhaps there is a bug here based on software versions. @KevinR99 can you please open a TAC case to get to the bottom of it?

topic Re: SD Access port assignment in Software-Defined Access (SD-Access)

SD Access port assignment

Re: SD Access port assignment

Re: SD Access port assignment