https://community.cisco.com/t5/software-defined-access-sd-access/sd-access-fib-loopback0-change-ip/m-p/5225890#M3750 <P>Hi,</P> <P>I have a working location with single 9300X working as FIB - i.e. it runs edge, contorl, border and also embedded WLC functionality.</P> <P>The fabric is working good. But now I need to change the Loopback0 IP address (due to global network renumbering).</P> <P>Is there a safe way to change it?</P> <P>I mean, I can shortly remove the EN|BN|CP functionality, if needed. I just want to avoid wiping out everything and starting the discovery/fabric configuration from scratch.</P> <P>Any suggestion appreciated!</P> <P>IGOR</P> Mon, 18 Nov 2024 13:04:43 GMT igor-k 2024-11-18T13:04:43Z https://community.cisco.com/t5/software-defined-access-sd-access/sd-access-fib-loopback0-change-ip/m-p/5225890#M3750 <P>Hi,</P> <P>I have a working location with single 9300X working as FIB - i.e. it runs edge, contorl, border and also embedded WLC functionality.</P> <P>The fabric is working good. But now I need to change the Loopback0 IP address (due to global network renumbering).</P> <P>Is there a safe way to change it?</P> <P>I mean, I can shortly remove the EN|BN|CP functionality, if needed. I just want to avoid wiping out everything and starting the discovery/fabric configuration from scratch.</P> <P>Any suggestion appreciated!</P> <P>IGOR</P> Mon, 18 Nov 2024 13:04:43 GMT https://community.cisco.com/t5/software-defined-access-sd-access/sd-access-fib-loopback0-change-ip/m-p/5225890#M3750 igor-k 2024-11-18T13:04:43Z