topic Voice Translation Rules -CME/CUE in Unified Communications Infrastructure

Voice Translation Rules -CME/CUE

Ray Delahoussaye — Tue, 19 Mar 2019 16:01:27 GMT

Can anyone tell me the command line to add a voice translation rule for forwarding a # temporarily??

CME/CUE Version 8.5

I need number 512-333-3444 forwarded to 512-519-0056

and I need to know how to delete that rule once I no longer need it

I believe I would start in config t

then : voice translation - rule 3

rule 1

then not sure after that 🙂

would really love some help on this today!

Ray Delahoussaye

There are plenty of documents

Jaime Valencia — Fri, 09 Jan 2015 19:32:14 GMT

There are plenty of documents explaining how to configure voice translation rules on cco, have you reviewed them???

i looked at a few but haven't

Ray Delahoussaye — Fri, 09 Jan 2015 20:52:50 GMT

i looked at a few but haven't seen any specifically for voice translation for forwarding

maybe I was looking in the incorrect place

You can use num-exp command

Suresh Hudda — Sat, 10 Jan 2015 15:02:48 GMT

You can use num-exp command which is similar to translation rule..test it out

R1 (Config) num-exp 5123333444 5125190056

Suresh

Hi suresh!do I give it a name

Ray Delahoussaye — Mon, 12 Jan 2015 16:51:08 GMT

Hi suresh!

do I give it a name or is it just

config t

R1 num-exp 5123333444 5125190056

is there a space between the two numbers??

Ray

yes there is a space between

Suresh Hudda — Mon, 12 Jan 2015 17:06:07 GMT

yes there is a space between numbers & no need to give any name,just goto conf T mode and type this and test.

Suresh

Thank you Suresh,I tried it.

Ray Delahoussaye — Mon, 12 Jan 2015 17:49:49 GMT

Thank you Suresh,

I tried it. I get Invalid Character detected on the R1

I assumed I needed that part as well or should I leave it out?

Ray

:-) don't mention R1, just

Suresh Hudda — Mon, 12 Jan 2015 18:04:05 GMT

🙂 don't mention R1, just copy below in co fig t mode..

num-exp 5123333444 5125190056

Suresh

it did not work.people

Ray Delahoussaye — Tue, 13 Jan 2015 19:57:15 GMT

it did not work.

people attempting to send to the fax# just get a fast busy.

might be something else going on.

command and function may be correct but could possibly be another issue within our system