topic Hi Manish,Thanks for reply,I in Unified Communications Infrastructure

Expressway with CUCM 7.1.5

Cisco Kbsl — Tue, 19 Mar 2019 15:22:00 GMT

Is there any limitations to use Cisco Expressway with CUCM 7.1.5? I was not able any compatibility info between expressway and CUCM

Thanks

Hi,Please check the following

Manish Gogna — Mon, 07 Jul 2014 07:30:23 GMT

Hi,

Please check the following compatibility matrix, support with cucm 7.x is not listed

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/uc_system/unified/communications/system/versions/IPTMtrix.html#wp1016708

HTH

Manish

Hi Manish,Thanks for reply,I

Cisco Kbsl — Mon, 07 Jul 2014 08:01:09 GMT

Hi Manish,

Thanks for reply,

I saw this table but I was not figure out how to check cross compatibility with this. According to this CUCM 7.1.5 do not compatible with any Cisco TelePresence VCS Expressway

Also I want check compatibility of Expressway C/E with CUCM (not VCS)

Also this document says

"This table identifies the components and software release versions used in the collaboration system validation test beds for Cisco Collaboration Systems releases. Table cells with dashes indicate products that were not part of the system validation test bed"

I dont know whether I am seeing this not correctly 🙂

Can you pls clarify this?

Thanks

Hi,If you check the

Manish Gogna — Mon, 07 Jul 2014 09:37:50 GMT

Hi,

If you check the Configuration guides for Expressway with CUCM, it is only available for version 8.x onwards

http://www.cisco.com/en/US/products/ps13435/products_installation_and_configuration_guides_list.html

http://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/expressway/config_guide/X8-1/Cisco-Expressway-SIP-Trunk-to-Unified-CM-Deployment-Guide-CUCM-8-9-and-X8-1.pdf

I do not see a separate compatibility matrix for Cisco Expressway with CUCM, but the configuration guides are a good [pointer towards the cucm version which the Expressway supports.

HTH

Manish

PrerequisitesEnsure that you

Jaime Valencia — Mon, 07 Jul 2014 15:16:37 GMT

Prerequisites
Ensure that you are running the following software versions:
VCS X8.1.1 or later
Unified CM 9.1(2)SU1 or later and IM & Presence 9.1(1) or later

http://www.cisco.com/c/dam/en/us/td/docs/telepresence/infrastructure/vcs/config_guide/X8-1/Mobile-Remote-Access-via-VCS-Deployment-Guide-X8-1-1.pdf