topic 1) i used the location not in Wireless

CMX 10.2.3

moh_efrangi — Mon, 05 Jul 2021 13:02:20 GMT

Dear 's

i have a CMX virtual version 10.2.3 and Cisco WLC 5520 , i import the MAP and exported by using prime and i added the WLC and it give active

but now i am so confused cause i cannot find a helpful document about this subject so my Question as below :

1) i used the location not presence so do i need to use prime or not and if i need is there any document for that

2)after i add the controller i cannot see any access point , do i need any configuration for that from the WLC side and CMX ? if yes is there any document

3) for client and Heat map the same i cannot see any thing ? is there any document for that

guys it's i am struggling here any helpful document will be nice

thanks

mohammed

1) i used the location not

Rasika Nayanajith — Tue, 25 Oct 2016 19:16:39 GMT

1) i used the location not presence so do i need to use prime or not and if i need is there any document for that

You need Cisco PI to import maps to CMX location.

2)after i add the controller i cannot see any access point , do i need any configuration for that from the WLC side and CMX ? if yes is there any document

You need to synchronize controller information to CMX.

Refer below post as you may find some useful information

https://mrncciew.com/2016/06/10/cisco-cmx-10-2-part-2/

HTH

Rasika

***Pls rate all useful responses ***

Hi

Andrew MacTaggart — Tue, 25 Oct 2016 19:17:11 GMT

Assuming you have configured CMX and controller already

As far as I know

Prime is currently used only for maps.

so import map, size correctly, add APs to map and then export maps.

Import map to cmx and you will see clients in CMX.

[cmxadmin@CMX ~]$ cmxctl config maps import

you can choose to import a file or directly from PI

Hi Andrew

moh_efrangi — Wed, 26 Oct 2016 05:23:45 GMT

Hi Andrew

thanks for your answer i already exported the map's , but without using any AP ,i install PI just for that without any configuration or adding any access point

is it possible to work like that

thanks

HI Rasika;

moh_efrangi — Wed, 26 Oct 2016 05:28:36 GMT

HI Rasika;

thanks a lot your post really help me , but it's the same issue i cannot see any access point

do i need to add the access point to the PI and after that exporting the map

thanks

Hi

Andrew MacTaggart — Wed, 26 Oct 2016 12:27:30 GMT

Add controller to PI

Add map

Add APs and place APs to map

and then export

in CMX the APs will display numbers which indicates # of clients connected