https://community.cisco.com/t5/wireless/mobility-controller-configuration/m-p/3954216#M103857 <P>Hi,</P><P>&nbsp;</P><P>I have&nbsp;WS-C3650-24PS-Swith acting as Mobility controller and two Aps are registered here. The show wireless summary result shows the Ap Radios status as below. Can you tell me how to enable this radio.?</P><P>device(config-if)#do sh wireless summ</P><P>Access Point Summary</P><P>Total Up Down<BR />-----------------------------------<BR />802.11a/n 2 0 2<BR />802.11b/g/n 2 0 2<BR />All APs 2 2 0</P><P>Client Summary</P><P>Current Clients : 0<BR />Excluded Clients: 0<BR />Disabled Clients: 0</P> Mon, 05 Jul 2021 18:15:06 GMT abinaya.2.r 2021-07-05T18:15:06Z https://community.cisco.com/t5/wireless/mobility-controller-configuration/m-p/3954216#M103857 <P>Hi,</P><P>&nbsp;</P><P>I have&nbsp;WS-C3650-24PS-Swith acting as Mobility controller and two Aps are registered here. The show wireless summary result shows the Ap Radios status as below. Can you tell me how to enable this radio.?</P><P>device(config-if)#do sh wireless summ</P><P>Access Point Summary</P><P>Total Up Down<BR />-----------------------------------<BR />802.11a/n 2 0 2<BR />802.11b/g/n 2 0 2<BR />All APs 2 2 0</P><P>Client Summary</P><P>Current Clients : 0<BR />Excluded Clients: 0<BR />Disabled Clients: 0</P> Mon, 05 Jul 2021 18:15:06 GMT https://community.cisco.com/t5/wireless/mobility-controller-configuration/m-p/3954216#M103857 abinaya.2.r 2021-07-05T18:15:06Z https://community.cisco.com/t5/wireless/mobility-controller-configuration/m-p/3954459#M103858 <P>Did you check radio band is enabled for 2.4GHz &amp; 5GHz</P> <P>&nbsp;</P> <P>SW2(config)#no ap dot11 24ghz shutdown</P> <P>SW2(config)#no ap dot11 5ghz shutdown</P> <P>&nbsp;</P> <P>HTH</P> <P>Rasika</P> <P>*** Pls rate all useful responses ***</P> Thu, 07 Nov 2019 03:35:48 GMT https://community.cisco.com/t5/wireless/mobility-controller-configuration/m-p/3954459#M103858 Rasika Nayanajith 2019-11-07T03:35:48Z