topic Re: Ap fall back option in Wireless

Ap fall back option

mina_raouf — Mon, 05 Jul 2021 15:39:07 GMT

is it mandatory for the AP fall back option to work to have all the controllers in the same mobility group or not ? Noting that the controllers are not on the same site and they are physically separated in different sites and I am not caring about seamless handover, it will be configured just for redundancy

The running IOS on the WLC now is 8.3.133.0

Re: Ap fall back option

Sandeep Choudhary — Tue, 22 May 2018 11:13:18 GMT

Hi,

Yes you should have same Mobility Group name if you need AP failover.
An AP will not move to a controller that is not in the same mobility group as its current controller if that controller fails.
AP learns of all the controllers configured in that mobility group.

If you want to have more control over how the APs move between controllers on your network, you can configure the APs with Primary, Secondary & Tertiary controller names. With the controller name configured on APs, the APs always try to register the primary controller first. Should the primary controller go down, the AP tries to register with the secondary controller. If the AP is not able to join any of the configured controllers, it try to join any controller with Master Controller setting configured, or if no Master Controller, then the least loaded controller in the Mobility Group.

Regards

Dont forget to arte helpful posts

Re: Ap fall back option

mina_raouf — Tue, 22 May 2018 11:17:54 GMT

I will configure the primary and secondary controller statically on the AP , so AP should learn the info for its list of WLCs , if those 2 WLCs are not on the same mobility group and the primary one fails, so the AP won't move to the secondary WLC unless it is defined in a mobility group ?

Re: Ap fall back option

Sandeep Choudhary — Tue, 22 May 2018 11:23:26 GMT

yes you are right.

Regards

Dont forget to rate helpful posts

Re: Ap fall back option

mina_raouf — Wed, 23 May 2018 19:49:28 GMT

I tested on a lab environment and the AP failover to the secondary WLC then fall back to the primary when it comes up and both WLCs weren't on the same mobility group and all works fine

I reset the AP as well and when the AP comes up it was storing the primary and secondary configuration

Can anyone clarify this behavior?

Re: Ap fall back option

MichaelDuong6743 — Wed, 30 Oct 2019 23:23:25 GMT

From my working experience, controllers do not have to be in the same mobility group. APs will join the Secondary and Tertiary controller, in that order, as the primary controller goes down.

Re: Ap fall back option

Sandeep Choudhary — Thu, 31 Oct 2019 13:01:36 GMT

Yes thats ok.

In my last posts I wrote you should have..but its not a must.

As long as wlc1 has wlc 2 Mac, ip and mobility name and vice versa... you should be fine & it will work.