topic Re: Wireless AP HTTP Error 404 in Wireless

Wireless AP HTTP Error 404

BharathDhanaraj — Mon, 05 Jul 2021 15:12:01 GMT

Hi,

My device with Version 15.3(3)JD, RELEASE and model No. AIR-CAP1702I-D-K9

I've logged into the device and enable http and https but when I login using the IP mentioned in the BVI.

I get 404 error.

Interface IP-Address OK? Method Status Protocol
BVI1 192.168.88.32 YES DHCP up up
GigabitEthernet0 unassigned NO unset up up
GigabitEthernet1 unassigned NO unset administratively down down

Any Solution ??

Re: Wireless AP HTTP Error 404

Flavio Miranda — Thu, 01 Feb 2018 16:36:17 GMT

Error 404 means "server could not find what was requested". Did you enabled and save it?

-If I helped you somehow, please, rate it as useful.-

Re: Wireless AP HTTP Error 404

BharathDhanaraj — Thu, 01 Feb 2018 17:36:55 GMT

The error started only 404.
I've saved the coffee and restarted the AP also

Re: Wireless AP HTTP Error 404

Flavio Miranda — Thu, 01 Feb 2018 17:38:35 GMT

HTTP/HTTPS error are well documented and they have a meaning. That´s why I add this info.

-If I helped you somehow, please, rate it as useful.-

Re: Wireless AP HTTP Error 404

Rich R — Fri, 02 Feb 2018 13:41:02 GMT

404 = file not found.

Those files are in a directory created when the .tar file is extracted to flash along with the IOS image.

How did you install the IOS - by just copying on the IOS image or by using the archive download-sw command with the .tar file from cisco software download?

If you use archive download-sw (recommended) then it extracts the image and all the files required by the web interface and sets the boot variables.

If you copy the IOS manually then you'll need to copy all those files and folders yourself manually too.

Hope that helps 🙂

Rich

Re: Wireless AP HTTP Error 404

pbonner — Fri, 10 Apr 2020 14:25:17 GMT

I've exact the same Problem.

You get 404 errors with all kind of Browsers. CLI is working fine.

All firmwares after JJ1 have this Problem.

Re: Wireless AP HTTP Error 404

BharathDhanaraj — Sat, 11 Apr 2020 11:20:25 GMT

Hi,

I was trying to install the AP as a stand alone mode & later found out that the IOS in the AP was set to talk to a controller.

Changed the IOS and added few files for browser based access.

I was able to get the HTTP access.

Re: Wireless AP HTTP Error 404

pbonner — Mon, 13 Apr 2020 10:11:40 GMT

I´ve tried an manually install… (JPJ3)

You can go on AP Website, but you can´t Change anything...

Try (Easy Setup - Network configuration - static IP, and type your new IP - and apply)

you will get an 404 😞

I´ts the same with 90% of the Settings.

best regards Paddy