https://community.cisco.com/t5/wireless/local-eap-fast-not-working/m-p/2087156#M10644 <P>Refer "<A name="wlc2">Configure the WLAN for EAP-FAST Authentication" </A></P><P>from</P><P>http://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/99791-eapfast-wlc-rad-config.html#wlc2</P><P>&nbsp;</P><P>&nbsp;</P> Wed, 09 Jul 2014 11:39:01 GMT Saurav Lodh 2014-07-09T11:39:01Z https://community.cisco.com/t5/wireless/local-eap-fast-not-working/m-p/2087155#M10643 <P>Folks, </P><P>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; I can get eap-tls local to work on a 2106 controller with certificates generated using OpenSSL but eap-fast is failing. I am using the any connect client version 3.0.10057 , the code on the controller is 7.0.116.0. The logs say that ananumous user is invalid. I did go through the nam editor and created a profile where I specified a user and enabled PAC provisioning . </P><P></P><P>Any assistance would be highly appreciated. </P> Sun, 04 Jul 2021 06:00:12 GMT https://community.cisco.com/t5/wireless/local-eap-fast-not-working/m-p/2087155#M10643 tpahuja 2021-07-04T06:00:12Z https://community.cisco.com/t5/wireless/local-eap-fast-not-working/m-p/2087156#M10644 <P>Refer "<A name="wlc2">Configure the WLAN for EAP-FAST Authentication" </A></P><P>from</P><P>http://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/99791-eapfast-wlc-rad-config.html#wlc2</P><P>&nbsp;</P><P>&nbsp;</P> Wed, 09 Jul 2014 11:39:01 GMT https://community.cisco.com/t5/wireless/local-eap-fast-not-working/m-p/2087156#M10644 Saurav Lodh 2014-07-09T11:39:01Z