WGB feature

egon — Mon, 05 Jul 2021 19:47:37 GMT

Hello,

we'd like to set-up workgroup bridge feature on new Catalyst 9800 WLC with transparency for VLAN-ID's (trunk via WGB) like on following link:

https://www.cisco.com/c/en/us/support/docs/wireless-mobility/service-set-identifier-ssid/211293-Configure-Work-Group-Bridge-WGB-Multip.html

From what we understand, ACCESS-mode of only one VLAN is possible on version 16.12.02s?

wireless profile policy test-wgb
aaa-override
no central authentication
description test-wgb
idle-timeout 3600
session-timeout 300
vlan 49
wgb broadcast-tagging
wgb vlan
no shutdown

WLC(config)#wireless profile policy test-wgb
WLC(config-wireless-policy)#wgb ?
broadcast-tagging Configures WGB broadcast tagging on a WLAN
vlan Configure WGB vlan client support

WLC(config-wireless-policy)#wgb vlan ?
<cr> <cr>

WLC(config-wireless-policy)#vlan ?
WORD Enter Vlan

Best regards!

Re: WGB feature

Grendizer — Thu, 26 Nov 2020 04:07:20 GMT

You need those commands as you mentioned. The VLAN you set it up for the policy profile is not used, assuming the WGB will connect to a switch by trunk, the wired clients will use whatever connected switch switchport VLAN configured but you need to define those VLANs from the WGB AP.

topic WGB feature in Wireless

WGB feature

Re: WGB feature