topic Re: Wireless Bridges won't associate in Wireless

Wireless Bridges won't associate

arshdeepsingh.grover — Mon, 05 Jul 2021 14:51:13 GMT

I have two 1602E configured as wireless bridges.

they connect fine when are close to each other, but when put around 25 meters apart disassociate.

Can someone help me in resolving this issue.

Thanks

Re: Wireless Bridges won't associate

Flavio Miranda — Sun, 12 Nov 2017 15:36:43 GMT

Hi @arshdeepsingh.grover

They are standalone or they are on WLC?

What about their power? As per you description, looks like they have weak signal.

When they are 25 meters apart, do they

free line of sight or there's some obstacle between them?

-If I helped you somehow, please, rate it as useful.-

Re: Wireless Bridges won't associate

arshdeepsingh.grover — Sun, 12 Nov 2017 22:23:04 GMT

These are Standalone APs

The Power is set to max level

and there is a clear line of sight between these APs

Re: Wireless Bridges won't associate

Scott Fella — Sun, 12 Nov 2017 22:27:51 GMT

What antennas do you have one these 1602e’s? Also what band are you using as the backhaul?

Antenna gain can help depending what you are trying to do here but also the band is where you might want to play with also.

Re: Wireless Bridges wton't associate

Flavio Miranda — Sun, 12 Nov 2017 22:51:43 GMT

I'd recommend a site survey just to make sure you don't have a strong interference weakening the signal. If not, I'd say you have some faulty AP in your hands. 25 meters is too close.

There are some commands you can run and share the output. Also, if possible, share show running-config.

debug mesh security events enable
debug mesh security message enable
debug dot1x events enable
debug dot1x packet enable

-If I helped you somehow, please, rate it as useful.-

Re: Wireless Bridges won't associate

arshdeepsingh.grover — Mon, 13 Nov 2017 11:18:28 GMT

DUINBW01#sh run ssid WGB-SSID
Building configuration...

Current configuration:
dot11 ssid WGB-SSID
vlan 10
authentication open
authentication key-management wpa version 2
infrastructure-ssid
wpa-psk ascii 7 1530194D002D781678632163
end

DUINBW01#sh run int do1
Building configuration...

Current configuration : 247 bytes
!
interface Dot11Radio1
no ip address
no ip route-cache
!
encryption vlan 10 mode ciphers aes-ccm
!
ssid WGB-SSID
!
antenna gain 0
peakdetect
dfs band 3 block
stbc
beamform ofdm
channel dfs
station-role root bridge
distance 1
end

DUINBW01#sh run int do0
Building configuration...

Current configuration : 204 bytes
!
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption vlan 10 mode ciphers aes-ccm
!
ssid WGB-SSID
!
antenna gain 0
stbc
beamform ofdm
station-role root bridge
distance 1
end