topic EAP and AES CCM on 1310 AP/Bridges in Wireless

EAP and AES CCM on 1310 AP/Bridges

trbcohen84 — Sun, 04 Jul 2021 04:22:36 GMT

I have a pair of Cisco 1310 AP/Bridges. I am attempting to use them only in bridge mode. I can get them configured using open/wep/wpa shared keys, but when I attempt to configure them using AES CCM and Network EAP I can not get them to talk to each other. The Root Bridge which is setup as the Radius with a dedicated user for the Non-Root gives the error of "NAS shared key mismatch with XX.XX.XX.XX" and the Non-Root Bridge gives the error Interface Dot11Radio0, cannot associate EAP authenticating" I have checked the Radius shared key on the Root and also ensured that the username and password on the non-root match. I can't find much on this on the interwebz. Any help will be greatly appreciated.

EAP and AES CCM on 1310 AP/Bridges

George Stefanick — Fri, 13 Jan 2012 17:28:35 GMT

Ben,

Can you post the show run on each ?

EAP and AES CCM on 1310 AP/Bridges

Stephen Rodriguez — Fri, 13 Jan 2012 17:30:20 GMT

Ben,

can you post the configs of the root and non-root bridges?

the key mismatch error means the key you entered in the local-radius config, and the ip radius-server lines do not match. When you enter these you want to use 'key 0' not 'key 7'. the AP will encrypt the key after you enter it.

Steve