topic Mobility Express after configuring using over the air wizard in Wireless

Mobility Express after configuring using over the air wizard

Azariel Rodriguez Parra — Mon, 05 Jul 2021 15:29:56 GMT

Hi after configuring Mobility Express using over the air setup wizard, I can not open the web page of the controller, the ping answer and I can enter via ssh but if I try to open via a web browser it don´t work.

The ME version is 8.2.15.

If I configured via cli but is the same problem.

I hope you can help me, Thanks...

Re: Mobility Express after configuring using over the air wizard

Sandeep Choudhary — Wed, 11 Apr 2018 05:23:25 GMT

did you configure the swicthport corerctly where ME AP is connected ?

can you past the swicth port conifg here..

Regards

Dont forget to rate helful post

Re: Mobility Express after configuring using over the air wizard

Azariel Rodriguez Parra — Wed, 11 Apr 2018 15:09:08 GMT

hi this is the configuration:

Interface GigabitEthernet1/0/1
description Connected to Master AP
switchport trunk native vlan 900
switchport mode trunk
switchport trunk allowed vlan 5,255,900

I use a switch witout configuration and a swith with configuration, after configured ME but the problem is the same.

Thanks...