topic Re: EAP-PEAP AUTHENTICATION in Wireless

EAP-PEAP AUTHENTICATION

akobwaycct — Sat, 03 Jul 2021 20:42:27 GMT

am using CISCO ACS SE to authenticate my users who connect to my wireless network from the microsoft AD..am using EAP-PEAP.

the authentication works fine the problem is that after authenticating and associating my Client connects for about 5 minutes and reconnects again and it does this continously in intervals of 5 minutes..whare could i have gone wrong.

Re: EAP-PEAP AUTHENTICATION

ebreniz — Tue, 06 Mar 2007 14:43:44 GMT

I don't think there is any issue with the authentication server unless you have set the client session interval to as low as 5 mins. Could you check what is the client session interval configured? Does it happen to all clients?

Re: EAP-PEAP AUTHENTICATION

akobwaycct — Tue, 06 Mar 2007 14:50:40 GMT

yes it happens to all clients...where exactly do i check the client session interval in the ACS or WLC.

Re: EAP-PEAP AUTHENTICATION

Vivek Santuka — Thu, 08 Mar 2007 11:00:34 GMT

Hi,

On the ACS->Group Setup Select Radius IETF Attribute 27 - Session Timeout - and set it to a high value.

Regards,

Vivek