topic Hi Rasika, in Wireless

3850 WLC: Enabling Access Points via CLI

Heinz Schwarzfeuer — Mon, 05 Jul 2021 13:24:18 GMT

Hi,

we have a couple of 2802 APs registered on a 3850 (16.3 Denali).

Obviously the "Admin Status" of the APs must be set to "Enable" to put them into operation. I found it in the web gui (see attachment).

Does someone know how to do it via CLI?

Thanks!

Hi

Rasika Nayanajith — Thu, 19 Jan 2017 19:59:51 GMT

You can use below CLI command

3850#ap name <AP_Name> no shutdown

An example shown below

3850-1#ap name 3702-2 no shutdown 

3850-1#sho ap config general | in Admin
Administrative State : Enabled

HTH

Rasika

*** Pls rate all useful responses ***

Hi Rasika,

Heinz Schwarzfeuer — Thu, 19 Jan 2017 21:40:53 GMT

Hi Rasika,

that´s it! Thanks a lot!

Heinz