topic Yes, use GUI. in Wireless

IP address of client and joined access point in WLC

Integration Support — Mon, 05 Jul 2021 12:24:32 GMT

Hey,

How to view IP addresses of joined clients and access points in WLC ? Is there any way ?

Yes, use GUI.

Leo Laohoo — Tue, 12 Jul 2016 11:47:53 GMT

Yes, use GUI. On the main page of the WLC, click "Clients". Depending on the firmware, the IP address of the clients and the AP joined will be displayed.

Hey

Integration Support — Tue, 12 Jul 2016 11:51:07 GMT

Hey

In GUI i can see only MAC addresses

See screenshots attached

That's because the WLC is

Leo Laohoo — Tue, 12 Jul 2016 11:58:36 GMT

That's because the WLC is running an OLD firmware. I believe starting from firmware 8.0 this feature is enabled.

I'm running 7.0.252.0

Integration Support — Tue, 12 Jul 2016 13:22:22 GMT

I'm running 7.0.252.0

This is not the issue

I'm now can see the IP address of the APs . I just needed to click on detail (see screenshots)

or > Monitor > statistics > AP Join

Now I'm only stuck with clients IP addresses. I don't find the way to find clients IP addresses. Is there any command in CLI ?

Now I'm only stuck with

Leo Laohoo — Tue, 12 Jul 2016 22:08:15 GMT

Now I'm only stuck with clients IP addresses. I don't find the way to find clients IP addresses. Is there any command in CLI ?

And this is what I've been saying. If you want a display which shows the client's MAC address, IP address, username, etc (see image below), then the controller firmware version will not support this. The feature was enabled in 8.0.X.X. Release Notes for 8.0.X firmware can be found HERE.

hi,

johnlloyd_13 — Wed, 13 Jul 2016 02:10:58 GMT

hi,

try this command if it's available:

show ap join stats summary all

Re: hi,

i-chaudhry — Thu, 08 Nov 2018 09:59:28 GMT

Thank you. "show ap join stats summary all" is what I was looking for as well.